Description of Advanced Hydrology Study System
The unit comprises a sand tank, made of stainless steel, measuring 2 meters by 1 meter. Water may be input to the sand tank from spray nozzles located above the tank (simulating rainfall), from an inlet tank simulating a river flow or from two french drains buried in the sand at either end of the tank. The water is output either from an outlet tank and flow measurement system located at the end of the main sand tank, from one or both of the two wells located in the tank, or one or both of the French drains.
A large plastic sump tank is located under the sand tank.
Capabilities of Advanced Hydrology Study System
Features of Advanced Hydrology Study System
Specification of Drainage and Seepage Tank
Description of Drainage and Seepage Tank
Specification of Ground Water Flow Unit
Description of Ground Water Flow Unit
Technical Specification of Ground Water Flow Unit
Technical Specification of Laboratory Flumes and Channels:
Depending on customer requirements, channels can be designed to incorporate the following alternative features:
Specification of Laser PIV System
Specification of Mobile Bed and Flow Visualisation Tank
Technical Specification of Mobile Bed and Flow Visualisation Tank
Specification of Rainfall Hydrographs
Technical Specification of Rainfall Hydrographs
Specification of Sediment Transport Demonstration Channel
Description of Sediment Transport Demonstration Channel
The unit consists of an inclinable channel mounted on a frame, together with a discharge tank and recirculating pump. To commence a demonstration, sand is placed evenly along the channel bed, between the inlet tank and the overfall discharge weir. Water is circulated around the system at one of the three selectable flow rates. The channel slope is adjusted by means of a fine screw jack to which an accurate slope indicator is attached. The channel sides are transparent in order that bed profile changes can be observed, and a section of one side is provided with graphical grid markings to permit quantitative assessments to be made of bedform dynamics.
Technical Specification of Sediment Transport Demonstration Channel
Specification of Wave Probe System
A simple and robust system for the measurement and recording of water wave profiles, which uses the principle of measuring the electrical conductivity between two parallel wires. The system is available in 1, 2 or 3 channel form and can display data by high speed recorder or input to a data logger. Alternative lengths of probe are 300mm or 500mm.
Description of Wave Probe System:
Features of Wave Probe System: